Hi~ i have question about sponge layer

[kobl1201]

Hello~

i want to apply sponge layer. Therefore, i change ana_sponge.h and then applied hear file.

and then i think i will turn on switch about sponge layer.

Which one should i turn on??

When i turned on the switch, which is LuvSponge and LtracerSponge, but the model didn't run.

Please help me~

[kate]

Did you turn on ANA_SPONGE and recompile? How did the model not run? Did it give you some error messages?

[kobl1201]

Hi Kate~

i compile Ana_sponge.

The model didn't give message. just stop the model like this.

** Omit ***

ndtfast, nfast = 40 56 nfast/ndtfast = 1.40000

Centers of gravity and integrals (values must be 1, 1, approx 1/2, 1, 1):

1.000000000000 1.039265571007 0.519632785503 1.000000000000 1.000000000000

Power filter parameters, Fgamma, gamma = 0.28400 0.21300

Metrics information for Grid 01:
===============================

Minimum X-grid spacing, DXmin = 1.19947258E+00 km
Maximum X-grid spacing, DXmax = 1.25659681E+00 km
Minimum Y-grid spacing, DYmin = 1.19974708E+00 km
Maximum Y-grid spacing, DYmax = 1.25650836E+00 km
Minimum Z-grid spacing, DZmin = 1.21951220E-01 m
Maximum Z-grid spacing, DZmax = 2.15106297E+02 m

Minimum barotropic Courant Number = 3.94115797E-03
Maximum barotropic Courant Number = 1.02664661E-01
Maximum Coriolis Courant Number = 1.83076144E-03



**************************************************************

At that time the model stopped.

[kate]

The next thing in my model output is the report from GET_STATE, followed by reports from get_idata and get_data. Are you expecting it to read anything from files, like initial conditions, boundary conditions or forcing?

If reading from a file fails, you should be getting a report on that too.

[kobl1201]

Hi kate

when i turn off LuvSponge, the model run.

but if i turn on the LuvSponge, the model stop above.

the problem is also same reason, which you told me???

thank you~

[kate]

I don't know why it stopped. I don't use the sponge options. I would have to watch it in a debugger to see what happened.