Inlet_test:the Swan output has no result

General scientific issues regarding ROMS

Moderators: arango, robertson

Post Reply
Message
Author
zip
Posts: 4
Joined: Tue Mar 26, 2019 11:17 am
Location: Tianjin University

Inlet_test:the Swan output has no result

#1 Unread post by zip »

Hello,everyone, I'm running the inlet_test case form https://www.myroms.org/wiki/INLET_TEST_CASE. It can be calculated normally without error in ROMS Log file. But I cannot find any data in the SWAN output(.mat). The SWAN output data(.mat) has only 16kb. Obviously there is a problem. I've checked the PRINT file of SWAN, and it only calculate for 1 step and get stuck. Everything in this case are copied form trunk and I didn't change anythiny. Could you tell me what the problem is?
Attachments
Snipaste_2021-12-27_17-16-55.jpg
Snipaste_2021-12-27_17-16-55.jpg (81.05 KiB) Viewed 1919 times
Snipaste_2021-12-27_17-10-15.jpg
Snipaste_2021-12-27_17-12-01.jpg

jcwarner
Posts: 1172
Joined: Wed Dec 31, 2003 6:16 pm
Location: USGS, USA

Re: Inlet_test:the Swan output has no result

#2 Unread post by jcwarner »

if you are going to use ROMS + SWAN coupling, then please use the COAWST code here:
https://github.com/jcwarner-usgs/COAWST

that should run 'as is' and give the outputs, this is an example test case.
thanks,
john

Post Reply