Hi,
i am having problem with running riverplume2 test case.
i get negative ubar values inside the river part i.e. water is flowing back to the direction of point source couple of steps away (zeta and vbar changes dont even seam to be big enough for it). i use five point wide inflow, open boundary conditions.
i have changed amount of water from the river and put inflow in first from all layers then from top 1/3 and also tried using just top layer but no success. also tried to turn of coriolis.
any idea what could be wrong or what should i change? i am sorry if my question is not well formulated i am not quite sure jet what is important and what is not, just trying to get started with things.
parameters in .h file:
#define UV_ADV
#define UV_COR
#define UV_QDRAG
#define UV_PSOURCE
#define DJ_GRADPS
#define TS_MPDATA
#define MIX_GEO_TS
#define TS_PSOURCE
#define NONLIN_EOS
#define SALINITY
#define MASKING
#define SOLVE3D
#define SPLINES
#define AVERAGES
#define AVERAGES_AKV
#define AVERAGES_AKT
#define AVERAGES_AKS
#define SOUTH_FSCHAPMAN
#define SOUTH_M2FLATHER
#define SOUTH_M3RADIATION
#define SOUTH_TRADIATION
#define NORTH_FSCHAPMAN
#define NORTH_M2FLATHER
#define NORTH_M3RADIATION
#define NORTH_TRADIATION
#define EAST_FSCHAPMAN
#define EAST_M2FLATHER
#define EAST_M3RADIATION
#define EAST_TRADIATION
#define WESTERN_WALL
#define N2S2_HORAVG
#define GLS_MIXING
#define CANUTO_A
#define ANA_FSOBC
#define ANA_M2OBC
#define ANA_PSOURCE
#define ANA_GRID
#define ANA_INITIAL
#define ANA_PSOURCE
#define ANA_SMFLUX
#define ANA_SRFLUX
#define ANA_SSFLUX
#define ANA_STFLUX
#define ANA_BSFLUX
#define ANA_BTFLUX