Ocean Modeling Discussion

The domain has large tidal flat area, shall I define the additional variables, e.g. WETDRY_MASK_* and the corresponding ZETA related with the critical water depth, in the initial file? Or shall I modify the code to run such case?
thanks very much

thanks Kate :P the variable for climatology time is 'tclim_' so I modified the inp_par.F by adding two lines in the DO loop if (Vname(5,varid).eq.'temp_time') Vname(5,varid)='tclm_time' if (Vname(5,varid).eq.'salt_time') Vname(5,varid)='sclm_time' it is ok now, the best way is modified the climatolo...

when I defined 'CLIMA_TS_MIX', and set the climatology file in the '*.in', it would pause after read the boundary file, and could not continue to read the climatology data. It is also found there is not 'idTclm' entrance in 'varinfo.dat'. Where shall I set the entrance for the T&S climatology da...

I am using ROMS 736 in ferret, the station results(e.g.ocean_sta.nc) always note error below: "*** NOTE: unsupported ordering of axes in variable u *** NOTE: The default ordering will be used *** NOTE: Axis S_RHO marked as DU *** NOTE: but it has different directions in grids. Axes in grids may...

When i try to run ROMS with data assimilation, model will be not converge and the float value written into TLMNAME and ADJNAME will grow larger and larger. Finally, the program terminated with the error msg: Numeric conversion not representable. I googled this error msg. If the float value is larger...

There are couple of bugs in hmixing.F around line 509. The southern boundary condition for Uvis3d_r and Vvis3d_r uses Jend instead of Jstr like in diff3d_u : IF (SOUTHERN_EDGE) THEN DO k=1,N(ng) DO i=IstrU-1,Iend # ifdef DIFF_3DCOEF # ifdef TS_U3ADV_SPLIT diff3d_u(i,Jstr-1,k)=diff3d_u(i,Jstr,k) diff...

thanks very much, the area with high steep topography always troubles the modeler

it is noticed that there are two new options 'UV_U3DV_SPLIT' and 'TS_U3ADV_SPLIT', but when I want to switch the default options in momentum and tracers equations to above options because I focuse on the slope area, the ROMS output of 'KINETIC_ENRG POTEN_ENRG TOTAL_ENRG NET_VOLUME' are "NAN&quo...

I am want to do an estuary simulation with the nested grid. can somebody infor me whether the ROMS can handle the nested grid, if it is ok how to modified the file of *.in?
thanks very much